paint "miscoat"

i began this session by putting on my p.p.e such as boots and gloves to protect my skins from any paint going into cuts i may have. "protection"
after I had my p.p.e on i then began collecting the materials "paint" and 1 bucket of water.

i then began mixing the paint and around 30% of water after i felt that the paint was ok for the miscoast i began putting a fine coat to show imperfections after i done the miscoat i then sanded down or fillered the bumb or hole down.

sanding /filling

firstly i started by putting on my ppe boots glove goggle and mask, i then began by making sure my mask was on before sanding the outside. i didnt need to do alot of sanding coz we wasnt getting mark for the outside of the bay, put i still make sure that it was smooth and ready to be fileld and painted.
i started at the bottom left side of the bay working my work up to the top sanding anything that felt out of place.
if i saw any holes or gaps i would fill them into after sanding "marking them out with a pencil soo i didnt lose them or forget". after sanding i started making some filler with lewis carefully making sure we didnt put too much water into the mix then using a scraper i filled everyhole hole or gap i marked out earlier.