concrete

firstly we started by putting on my ppe and getting the equipment that i would be using "
2 bags of ballast
1 bag of sharp sand
1 bag of cement"
1 in-mould
first i started by putting the ballast into a wheelbarrow i then started putting in the sharpsand and mixing them together i then added some cement and water and started mixing the ballast cement etc.. untill i felt that it was mixed i then started shoving the concrete into the in-mould until filled.
i then started tapping the corners to get the air bubbles out after i felt that all the bubbles was out i smooths the top of any extra water
i then left it to dry for 24hours then took it out carefully not to break after i reported to the site manager  and cleaned up my area.

string line 3-4-5

firstly i started by putting on some of my PPE boots and gloves and collecting the equipment that i would be using "string and garden wire and 6bricks to hold in place

i then started by making a left angle triangle " 90' angle" "with the string and holding it with bricks the measurements was 400cm/300cm/500cm
400cm down 300cm right-left 500cm across
i then tied around garden wire around the string where the string crossed over.
i then started making the right angle triangle into a square making sure that all corners was at a 90' angle

after i made the square i got the site manager to check the string line and then he gave me another task which was to take out a part of a corner and made sure all corners in the square was at 90'.
 after finishing that task i reported back to the site manager took a picture "with the big camera" and cleaned up my area.